Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://help.thunderheadeng.com/support/discussions. This forum site will be read-only for a while and eventually brought offline.  All new posts should be made on the new "help" site.

Author Topic: Polyurethane combustion heat to simulate a car fire.  (Read 154 times)

CarlosJavier

  • New Member
  • *
  • Posts: 2
    • View Profile
Polyurethane combustion heat to simulate a car fire.
« on: February 18, 2023, 06:26:12 pm »
Good evening,

I am simulating a car fire in a parking lot.

Considering the following parameters.

HRR = 4,800 Kw,

For the "Reaction" section, I have considered that polyurethane is being burned.

Quote
&REAC ID='POLYURETHANE', FYI='NFPA Babrauskas', FUEL='REAC_FUEL', C=6.3, H=7.1, O=2.1, N=1.0, SOOT_YIELD=0.1, RADIATIVE_FRACTION=0.35/

According to what I have studied, the heat of combustion can be calculated with the spreadsheet Combustion Calculator = https://files.thunderheadeng.com/support/files/Combustion_Calculator_v5-0.zip.

Then by copying the values of the products and by-products of the chemical equation into the spreadsheet Combustion Calculator,
I get a heat of combustion of 19,024 Kj/Kg which can be seen in the attached images.

But the problem is that I understand that the heat of combustion for a burning car must be between 24,000 to 26,000 Kj/Kg.
Does this mean that the polyurethane burner I chose in Pyrosim does not meet the heat of combustion I need?

Can someone provide me the correct chemical equation to produce the amount of heat of combustion as indicated in the standards (between 24 to 26Mj/Kg ?? ).

I hope your comments can help me.

Best regards.

Carlos P.




Logged