Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  


Forum moved to

Author Topic: Flashover point  (Read 685 times)


  • New Member
  • *
  • Posts: 4
    • View Profile
Flashover point
« on: April 14, 2020, 05:58:39 pm »

Hi, I have attached the project that I need to complete. This is due in a couple of days and I am new to the software so any help would be much appreciated.

1. How do I create an ignition source on an obstruction?
2. How do I calculate the flashover time and onset conditions of flashover and the minimum heat release rate that leads to flashover?
3. Also, how do I set an obstruction to be of a specific material? (say gypsum)