Public Forum > PyroSim

The smoke doesnt go up to the roof after simulation


Dear all!

I have a project where we are using the latest version of Pyrosim.

When finished simulating and trying to view the smoke produced by the fire, the smoke from the fire starts to travel up just a little bit(approx 2 metres), and then spreads horizontially and not touching the roof.

Does anyone know how to solve this issue?

Just for the record, once the smoke has filled the room with smoke at a height of approx 2 metres, THEN the rest of the smoke starts proceeding up to the roof..

Best regards

At the least, you are going to need to post your file in .psm or .fds format.  It seems that there is an issue with the geometry of your model, but it is impossible to tell from commentary alone.


[0] Message Index

Go to full version