Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://forum.thunderheadeng.com

Author Topic: change Exit Door to Normal door  (Read 1776 times)

Ewss

  • New Member
  • *
  • Posts: 4
    • View Profile
change Exit Door to Normal door
« on: November 04, 2016, 05:26:04 am »

Hi,

I have one question about change a Exit Door type to normal door how can i do it without delete exit door and make a door again?

Regards :)
Logged

Charlie Thornton

  • Thunderhead
  • *****
  • Posts: 851
    • View Profile
Re: change Exit Door to Normal door
« Reply #1 on: November 15, 2016, 02:43:39 pm »

Doors are identified as exit doors when <2 sides have walkable geometry defined. You can turn one into a normal door by adding a room on the empty side. If you have rooms on both sides of a green door, there is either have a tiny gap or I have occasionally seen problems with legacy models where two room sections have glitched and stacked up.
Logged