Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://forum.thunderheadeng.com

Author Topic: Unable to have more than 7 holes through one obstruction  (Read 2332 times)

andrew

  • New Member
  • *
  • Posts: 2
    • View Profile
Unable to have more than 7 holes through one obstruction
« on: April 02, 2014, 05:03:51 am »

H

I am working on a model in Pyrosim version 2013.1.1220.  I have a surface which has been imported as a dxf and wish to place a series of holes through this surface.  However I do not seem able to place more than 7 holes through it.  If I put more they are visible in Pyrosim but it doesn't put a hole through the surface.  As a check if I then reduce the size of this surface and created a new surface so that there was never any more than 7 holes per surface it worked fine.

I think this is a bug and have been able to replicate it on a small test case.

Thanks
Logged

Charlie Thornton

  • Thunderhead
  • *****
  • Posts: 851
    • View Profile
Re: Unable to have more than 7 holes through one obstruction
« Reply #1 on: April 02, 2014, 09:37:25 am »

Trying to reproduce this, it took me 39 holes before I found a what appears to be graphical problem in PyroSim. However, my version didn't seem to cause any problems outside of PyroSim.

Could you post your test case?
Logged

andrew

  • New Member
  • *
  • Posts: 2
    • View Profile
Re: Unable to have more than 7 holes through one obstruction
« Reply #2 on: April 02, 2014, 09:52:39 am »

Hi

Test case attached, this is what I did:
Created an obstruction
Created 1 hole
Used the copy/move command to copy the hole 10 times
Only 7 holes are visible

Thanks
Logged

Charlie Thornton

  • Thunderhead
  • *****
  • Posts: 851
    • View Profile
Re: Unable to have more than 7 holes through one obstruction
« Reply #3 on: April 03, 2014, 08:17:18 am »

Thank you!
Logged