Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  


Forum moved to

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - hey_youu

Pages: [1]
PyroSim / Re: Fire spread on facade
« on: May 15, 2020, 10:06:54 am »
Thank you Dave! With your timely help, i completed my project on time. How i can contact you for my promise?

PyroSim / Re: Fire spread on facade
« on: May 07, 2020, 10:40:51 am »
Hi Dave, how i can find the surface temperature of the wall?
Besides, if i change the heat release rate of the fire to 2500 kW, do you think this is reasonable?

PyroSim / Re: Fire spread on facade
« on: April 29, 2020, 05:07:04 am »
I have adjusted the heat of combustion of polyethylene. Where can i set the burning rate and what value i should put in?

PyroSim / Re: Fire spread on facade
« on: April 28, 2020, 11:15:30 am »
This is my model, thank you!

PyroSim / Re: Fire spread on facade
« on: April 27, 2020, 10:27:33 am »
Thank you for helping me once again. Yet, the fire still doesn't spread. I have split the the model to 4 meshes, opened the the boundaries and run the simulation up to 2 mins. The result is still similar to the previous one. What can i do?

PyroSim / Re: Fire spread on facade
« on: April 12, 2020, 10:27:13 am »
Thank you for answering! May i know more about the problems.

1. How i should divide the meshes? I should divide it over the whole model evenly or just divide it in the burning area (the vertical channel)?

2. How can i change my domain to the appropriate one? I cannot find it in the manual.

PyroSim / Fire spread on facade
« on: April 02, 2020, 12:00:58 pm »
Hi everyone!
i am trying to simulate a fire as the video below,

My PyroSim model and result are shown below. I have run the simulation for like 20 hours for a 90 seconds video, yet, the fire does not spread at all. What can i do to make the fire spread like the video and speed up the simulation? Thank you!


Pages: [1]