Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  


Forum moved to

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - asher

Pages: [1]
PyroSim / Importing atmospheric tank geometry in PyroSim to run in FDS
« on: August 01, 2019, 01:17:16 am »
I am doing a project which is based on domino effect analysis of fire on atmospheric tanks. I have made a CAD geometry and imported in the PyroSim. fire on one tank will give heat flux traveling to other tanks. I just want to know will FDS give reliable results with such geometry in PyroSim. How will FDS generate mesh for such circular geometry?

PyroSim / Issues while importing geometry
« on: July 03, 2019, 08:59:42 pm »
I am a neoteric user of PyroSim, I made a geometry on NX10 CAD software and imported the geometry in the PyroSim interface while importing it does not read the faces of my geometry. I would highly appreciate if I receive guidance on that.
The relevant images are attached below.
Thanks & Regards
UTP, Malaysia

Pages: [1]