Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  


Forum moved to

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - UNDI

Pages: [1]
PyroSim / mass flux of surf
« on: September 11, 2018, 03:27:00 am »

I ran a simulation about a burning chair ignite another chair.

According to the User guide, the mass flux was used for burner, but mass flux tab was in surfaces dialogue, can I use the ramp of mass flux and ignition temperature together to simulate the product after chair was ignited?

I tested the mass flux ramp, and if there is no heating source around, there won't be any species.

So my question is how to couple the ignition temperature and mass flux?

Pages: [1]