Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://forum.thunderheadeng.com

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - mehar.afreen

Pages: [1]
1
Hello All,

I need to complete a project which is having 4 buildings basements, I don't have very much time duration for this project , I need to complete these all buildings within a short period. One of the Building basement CFD is already I put in simulation with "Run FDS parallel" , But due to urgency , I need to launch another project simultaneously. As I tried to run another project with "Run FDS Parallel" but its not getting started even. Hence I tried to run another one with "Run FDS" only, and it is getting started & running properly.

I request you all please give your suggestions whether the these solver can be run together/Simultaneously. Whether its going to give me correct results. Whether I m doing it correctly?? :'( if I m wrong, Please advise what should i do to run them simultaneously.

Looking forward for your valuable response.

Thanks & Best Regards,
Ms. Mehar Ansari

2
Hello All,

I need to complete a project which is having 4 buildings basements, I don't have very much time duration for this project , I need to complete these all buildings within a short period. One of the Building basement CFD is already I put in simulation with "Run FDS parallel" , But due to urgency , I need to launch another project simultaneously. As I tried to run another project with "Run FDS Parallel" but its not getting started even. Hence I tried to run another one with "Run FDS" only, and it is getting started & running properly.

I request you all please give your suggestions whether the these solver can be run together/Simultaneously. Whether its going to give me correct results. Whether I m doing it correctly?? :'( if I m wrong, Please advise what should i do to run them simultaneously.

Looking forward for your valuable response.

Thanks & Best Regards,
Ms. Mehar Ansari

3
PyroSim / Simulation Is Not Getting Updated After 1369.8 Sec Since 3 Days
« on: October 25, 2016, 04:49:49 am »
Hi All,

Greetings of the day!

I am trying to simulate one project in FDS (using Pyrosim) , The simulation was working fine till 1369.8 Sec & but now it is stopped at 1369.8 sec and since 3 days if i am running the Smokeview file , i am getting results only upto 1369.8 sec although the "simulation time" is set for 1800 sec. Even the "FDS simulation window"  is showing that the " Time Remaining " value is continuously decreasing as per the  " time elapsed " increasing value. Both values are changing continuously . But smoke view file is not getting any results after 1369.8 sec. 

At very starting of the simulation of this project  , its FDS simulation window (which shows time steps) was also not getting updated after time 282.42 sec, but at that time we were able to see results in smokeview as it was giving results continuously even after 282.42 sec.

I am also attaching herewith the snapshot for FDS simulation window.

I request you all for your guidance to resolve this problem. Please advise.

Thanks & Best Regards,
Mehar Ansari (Ms)

Pages: [1]