Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://forum.thunderheadeng.com

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - seanmj98

Pages: [1]
1
PyroSim / Flashover point
« on: April 14, 2020, 05:58:39 pm »
Hi, I have attached the project that I need to complete. This is due in a couple of days and I am new to the software so any help would be much appreciated.

1. How do I create an ignition source on an obstruction?
2. How do I calculate the flashover time and onset conditions of flashover and the minimum heat release rate that leads to flashover?
3. Also, how do I set an obstruction to be of a specific material? (say gypsum)

2
PyroSim / Material to wall
« on: April 12, 2020, 10:01:29 pm »
If I made a wall obstruction and want it to be made out of gypsum, how do I do that? Do I use materials? Please explain

3
PyroSim / Help needed
« on: April 10, 2020, 07:03:56 pm »
I have attached the project I must complete. I am new to Pyrosim and am not sure how to operate the software. Could someone explain how I can determine the height of the neutral plane (the interface between the hot upper layer and the cool lower layer), the upper layer thickness, temperature, and optical density, the mass flow out from the opening, ? (kg/s), and the intensity of downward thermal radiation, incident on the floor.

Pages: [1]