Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Forum moved to https://forum.thunderheadeng.com

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - SAK

Pages: [1]
1
PyroSim / Slanted aircoil
« on: January 08, 2020, 06:38:19 am »
Hi,

Is it possible to model a slanted aircoil (2m x 12 m) at an angle of 75 degrees?

Thanks,

SAK

2
PyroSim / Non-linear Colorbar Distribution
« on: September 29, 2019, 08:44:04 am »
Hi All,

I was wondering if it is possible to change the distribution setting for the colorbar? For example, if the range is from 0 to 10, I would like the maximum color distribution between 0 to 4 (as shown attached) - blue to orange, and minimum between 4 to 10 (orange to red). Can we do this in pyrosim results?

Please advice.

Thanks in advance.

3
PyroSim / Pressure Drop for HVAC Fan
« on: June 20, 2018, 01:32:49 am »
Hi All,

Is it possible to put a single pressure drop value for a HVAC fan?

Also, is it possible to put a pressure drop across a hole?

Thanks in advance.

Kulkarni

4
PyroSim / Supply vent surface temperature
« on: May 14, 2018, 01:53:20 pm »
Hi,

I am supplying air into a room through a supply vent surface with a fixed temperature of 13 degrees (in the thermal boundary conditions), and exhaust is at TMPA through an exhaust vent. The ambient temperature is set to 25 degrees.

The results show the supply air temperature to be 19 degrees (instead of 13). How can I fix this?

Is the supply temperature set as per the ambient temperature?

(When I run the same problem with ambient temperature 13 C, the supply air is fixed throughout at 13.)

Thanks in advance,

Kulkarni

Pages: [1]