Thunderhead Engineering Forum

Please login or register.

Login with username, password and session length
Advanced search  


Forum moved to

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - JLo

Pages: [1]
PyroSim / Flux_limiter in PyroSim
« on: May 30, 2016, 04:53:05 am »
Just would like to confirm: It seems that the FLUX_LIMITER now should be applied by the ''additional fields'' with using manually typing? 

PyroSim / Re: ''New slab'' and ''New obstruction''
« on: May 30, 2016, 04:49:45 am »
Thanks for your reply, Jared!

PyroSim / Re: ''New slab'' and ''New obstruction''
« on: May 08, 2016, 02:24:57 pm »
Thanks for your reply. I've tried this before, then found that the "Record View" outputs are &OBST for both "new slab" and "new obstruction", that's why come up this question. The two commands are bit confusing as they seem very similar (almost same) in FDS. 

PyroSim / ''New slab'' and ''New obstruction''
« on: May 06, 2016, 10:01:47 am »
Hi all,

I'm modelling a heat transfer analysis of a concrete slab. The two commands ''New slab'' and ''New obstruction'' are very similar (define four and two points respectively). Is there any difference when using the two commands for modelling a slab under fire?


Pages: [1]