Thunderhead Engineering Forum

Public Forum => PyroSim => Topic started by: seanmj98 on April 14, 2020, 05:58:39 pm

Title: Flashover point
Post by: seanmj98 on April 14, 2020, 05:58:39 pm
Hi, I have attached the project that I need to complete. This is due in a couple of days and I am new to the software so any help would be much appreciated.

1. How do I create an ignition source on an obstruction?
2. How do I calculate the flashover time and onset conditions of flashover and the minimum heat release rate that leads to flashover?
3. Also, how do I set an obstruction to be of a specific material? (say gypsum)